
Heat Pump Emergency Heat: When to Use It (and When Not To)
Short answer: Leave your heat pump in normal Heat mode almost all the time. The emergency heat setting (often shown as EM HEAT, EMERG or EHEAT) shuts off the heat pump's compressor and heats the house with backup electric resistance heat only, which costs more to run. The P1 SmartTemp thermostat manual published by OG&E says to use it only when you suspect the heat pump is out of service "or the outdoor conditions are inefficient for the operation of the heat pump." If you switch it on, get the heat pump checked.
\nLast checked November 14, 2026, against DOE guidance and thermostat and program documents published by OG&E and Oncor. Check your own thermostat's manual too.
\nAuxiliary heat vs. emergency heat
\nMost heat pumps in Texas and Oklahoma have a backup heater, usually electric resistance strips in the indoor unit. (New to heat pumps? See how heat pumps work in winter.) The two thermostat terms describe different ways that backup runs:
\n| Auxiliary heat (AUX) | Emergency heat (EM HEAT) | |
|---|---|---|
| Who turns it on | The system, automatically | You, manually |
| Is the heat pump running? | Yes. Backup heat helps it | No. The compressor is locked out |
| When it's normal | Very cold weather and defrost cycles | Only if the heat pump isn't working |
A thermostat manual on OG&E's site describes EMERG mode this way: the thermostat "only controls the Emergency (Auxiliary) heat leaving the heat pump's compressor locked out." Another manual OG&E hosts says the EHEAT setting "uses auxiliary heat only. Heat Pump heat is not used."
\nWhy emergency heat costs more
\nA heat pump moves heat from outside air into the house instead of making heat from electricity, which is why it's efficient. Resistance strips make heat directly. DOE's homeowner guide for air source heat pumps calls auxiliary resistance strip heat "costly and inefficient," and DOE's Energy Saver Guide says backup electric-resistance heating is more expensive. Running on emergency heat means every hour of heat comes from the strips.
\nThat's why Oncor's efficiency program has homeowners who get a new heat pump confirm that they "were advised against using the emergency heat (EM HEAT) setting."
\nWhen emergency heat makes sense
\n- The heat pump has stopped working and the house is getting cold. Use emergency heat to stay warm, then get the system repaired.
- The outdoor unit is damaged or iced over and won't clear. DOE's guide says normal defrost cycles take about 5 to 15 minutes, and auxiliary heat may come on during them. That's normal. A unit that stays covered in ice or stuck in defrost needs an HVAC professional.
Don't switch to emergency heat just because it's cold outside or because the outdoor unit is defrosting. In normal Heat mode the system brings on auxiliary heat by itself when it needs help.
\nSigns your heat pump needs service
\nDOE's homeowner guide lists these signs that a heat pump isn't working properly:
\n- A sudden jump in the kWh on your electric bill
- The heat pump not running at all, or cycling on and off often
- The thermostat never reaching your set temperature
- "Auxiliary heat" showing on the thermostat all the time
- Frozen outdoor or indoor coils, or dirty coils or filters
- Unusual noise, strange smells, high humidity or mold near the unit
Keep backup heat from running up the bill
\n- Make small changes. DOE's guide says to avoid abrupt temperature changes of 3°F or more while the house is empty. DOE's Energy Saver Guide says not to set back a heat pump's thermostat manually if that turns on backup electric-resistance heat.
- Save setbacks for trips. DOE's guide says setbacks typically save energy only if you're away for more than a day.
- Use a thermostat made for heat pumps. DOE suggests a smart or programmable thermostat with functions suited to a heat pump. See smart thermostat rebates in Texas and Oklahoma.
- Change filters. DOE says to clean or change them once a month or as needed.
- Don't cover the outdoor unit in winter. DOE's guide says it needs airflow to pull heat from the air.
- Get a yearly check. In Oklahoma, PSO lists a heat pump tune-up rebate of up to $200, shown as a discount on the service provider's invoice. See our furnace and heat pump tune-up checklist and PSO rebates.
If backup heat runs all winter
\nA system that leans on backup heat in ordinary weather may be undersized, low on airflow, or set up wrong. DOE's guide says to have an HVAC professional check frequent auxiliary heat use. If the heat pump is old or failing, utility rebates may help with a replacement. See how much a heat pump costs in Texas, the disadvantages of a heat pump, heat pump vs furnace and Tulsa and Oklahoma City energy rebates.
\nFor every program in one place, see our Texas energy rebates and Oklahoma energy rebates guides.
\nFAQ
\nWhen should I use emergency heat on my heat pump?
Only when the heat pump isn't working, such as when it has stopped running or the outdoor unit is damaged or iced over and won't clear. The P1 SmartTemp thermostat manual on OG&E's site says to use it only when you suspect the heat pump is out of service "or the outdoor conditions are inefficient for the operation of the heat pump."
Is emergency heat the same as auxiliary heat?
They use the same backup heater. Auxiliary heat comes on automatically to help a running heat pump. Emergency heat is a setting you choose that turns the heat pump off and runs the backup heat alone.
Does emergency heat cost more?
Yes. It runs only electric resistance heat, which DOE calls more expensive and describes as costly and inefficient compared with the heat pump.
Should I use emergency heat during an ice storm?
Not just because of the storm. Normal Heat mode already brings on backup heat when needed. Switch to emergency heat only if the outdoor unit is damaged or iced over and the heat pump has stopped heating, then call for service.
Why does my thermostat say "aux heat"?
Auxiliary heat can come on in very cold weather, during defrost, or after a big jump in the setting. If it shows all the time, DOE's guide says to have an HVAC professional check the system.
Is Upgrade Rebates an HVAC company?
No. Upgrade Rebates is independent. We help homeowners understand which programs may fit and connect them with a licensed contractor.
Sources
\n- OG&E, P1 SmartTemp thermostat operating manual (EMERG mode): https://www.oge.com/documents/d/portal/p1-smarttemp-manual-pdf
- OG&E, Carrier ComfortChoice thermostat manual (EHEAT mode): https://www.oge.com/documents/d/portal/carrier-manual-pdf
- Oncor, Residential Host Customer Agreement (EM HEAT advisory): https://eepm.oncor.com/staging/spportal/Documents/Residential%20Host%20Customer%20Agreement.pdf
- U.S. Department of Energy, Energy Saver Guide: https://www.energy.gov/sites/default/files/2022-08/energy-saver-guide-2022.pdf
- U.S. Department of Energy, Building Science Education Solution Center, "You Installed an Air Source Heat Pump. Now What?": https://bsesc.energy.gov/sites/default/files/2024-09/CEE_You_Installed_an_ASHP_Now_What_TRC_01.16.24_1.pdf
- PSO, Heat Pump Tune-up: https://powerforwardwithpso.com/rebate/heat-pump-tune-up/
Heat pump leaning on backup heat? Tell us your ZIP and a few details about your home. We will email a confirmation. A specialist may follow up to go over your answers and the programs that may fit.
\nSee if you qualify →
Quick to check · No obligation.
Questions? Email [email protected].