Water heater installation in progress

What Size Tankless Water Heater Do I Need? A Sizing Guide

November 17, 2026•7 min read

Short answer: Size a tankless water heater by two numbers. The first is the hot water flow you need at the same moment, in gallons per minute (gpm). The second is the temperature rise, meaning how much the unit has to warm the incoming water. Add up the fixtures you run at once. Then choose a unit whose rated gpm at your temperature rise meets that total. In Oklahoma and North Texas, check one more number before you buy: the Uniform Energy Factor (UEF). It decides whether an Oklahoma Natural Gas or Atmos Energy rebate applies.

See if you qualify →
Quick to check · No obligation.

Last checked November 10, 2026. Rebate amounts come from Oklahoma Natural Gas's water heater sheet (Revised 09/26) and Atmos Energy's Mid-Tex rebate page. As of this check, ONG's rebate page says funds are currently available. Programs change, so confirm on the utility's site before you buy.

Why size matters more with tankless

A tank water heater stores hot water. A tankless unit makes it on demand, so its limit is flow rather than gallons stored. If the unit is too small, the shower runs lukewarm when someone starts the dishwasher. Buying the biggest unit isn't the answer either. A larger model costs more and may need a bigger gas line and different venting. The U.S. Department of Energy's Building America guide to tankless water heaters says sizing should be based on the maximum hot water flow needed at one time and the temperature rise required (Department of Energy measure guideline).

Step 1: Add up the fixtures you run at the same time

List the hot water uses that realistically overlap at your busiest moment, usually a weekday morning. Look up each fixture's flow rating. It is often stamped on the showerhead or faucet aerator, or listed in the product manual. Federal standards cap new showerheads at 2.5 gpm, and many are rated lower.

Busy-morning scenario (example)Fixture ratings you look upPeak flow
One shower + one bathroom faucetyour shower gpm + your faucet gpmthe sum
Two showers at onceshower 1 + shower 2the sum
Shower + dishwasher + kitchen fauceteach ratingthe sum

Use your own fixtures' ratings, not averages from the internet. Two older showerheads can need far more flow than two newer low-flow models.

Step 2: Find your temperature rise

Temperature rise = the temperature you want at the tap − the temperature of the water coming into the house.

  • The Department of Energy's sizing guide says most households want about 120°F at the tap.
  • Incoming water temperature comes from your local water utility. Use the winter (lowest) value, because that's when the unit works hardest.
  • If you don't know that number, ask your installer what incoming water temperature they design for in your area, and have them write it on the quote. That one line lets you compare quotes fairly.

Step 3: Match the unit's rating at that rise

Every tankless spec sheet has a chart of flow (gpm) at different temperature rises. Find the row for your rise from Step 2 and check that the unit's gpm meets or beats your total from Step 1.

Worked example (illustration only): say your busy morning is one shower plus one faucet, and the two ratings you looked up add to about 3.5 gpm. With a 70°F rise, you'd look for a unit rated at 3.5 gpm or more at 70°F rise on its spec chart. A unit that delivers 3.5 gpm only at a 45°F rise would fall short in winter.

Two other things to check on the spec sheet:

  • Minimum activation flow. The Department of Energy guideline notes that tankless units need a minimum flow, often in the 0.4–0.9 gpm range, before they turn on. Very low trickles may not trigger hot water.
  • Gas input (BTU) and venting. Higher-output gas units need enough gas line capacity and the right vent route. The same guideline lists evaluating the gas supply and venting as part of any retrofit.

Gas vs electric tankless: why the math differs

Gas-fired tankless units usually deliver much more flow at the same temperature rise than whole-house electric units. Electric models also need large electrical capacity. The Department of Energy guideline notes many units need 208/240 volts and substantial amperage. For a whole house, most Oklahoma and Texas homes with gas service size around a gas unit. Homes without gas often compare a heat pump water heater instead (water heater rebates by state).

Sizing and rebates: the UEF line

The size you pick doesn't change the rebate. The efficiency rating does. Check the UEF on the AHRI certificate or spec sheet before you sign.

Oklahoma Natural Gas (Oklahoma)

From ONG's official water heater sheet (Revised 09/26):

ONG water heater rebateRequirementAmount
New tankless water heaterUEF .80 or higherUp to $325
New condensing tank water heaterUEF .80 or higherUp to $650
Replace an electric water heater with a new natural gas water heater—Up to $1,050
Replace an electric water heater with a new natural gas tankless water heaterUEF .80 or higherUp to $1,375

ONG requires you to submit the application with a paid purchase and installation invoice (or an invoice with a paid stamp) within ONG's filing window after installation (see the sheet for the current window). As of November 10, 2026, ONG's rebate page says funds are currently available. Source: ONG water heater rebate sheet and oklahomanaturalgas.com/rebates. Full guide: ONG rebates 2026.

Atmos Energy (Mid-Tex: North, Central and East Texas)

From Atmos Energy's Mid-Tex rebate page (program year July 1, 2026 – June 30, 2027):

Atmos Mid-Tex tankless rebateRequirementAmount
Natural gas tankless water heater0.87 UEF or higherUp to $200
Natural gas tankless water heater0.95 UEF or higher, ENERGY STAR ratedUp to $300

Atmos sets an application window after purchase or installation. You need a recent Atmos bill and a receipt or contractor invoice. Source: Atmos Energy Mid-Tex appliance rebate program. Full guide: Atmos Energy rebates.

Note the different thresholds. A tankless unit at UEF 0.82 clears ONG's .80 line but misses both Atmos tiers. If you might move between service areas, or you're comparing models, write the UEF next to the gpm on every quote.

Electric utilities in Texas

Oncor, CenterPoint, CPS Energy and Austin Energy programs focus mostly on electric equipment. Some list rebates for heat pump water heaters. See all Texas programs and your utility's page: Oncor, CenterPoint, CPS Energy, Austin Energy.

Other utility programs for water heaters

In Oklahoma, PSO's rebate page lists water heater rebates on the electric side. Each program sets its own efficiency rating, so check the page before you choose a model.

See if you qualify →
We check your ZIP, your utility and your upgrade, then show the programs that fit.

When a heat pump water heater fits better

If your home has no gas service, adding gas just for a tankless unit adds cost and work. Heat pump water heaters are the main electric alternative, and several utilities list rebates for them. Compare both on our water heater rebates page. See what tankless installs typically involve in our tankless water heater cost guide.

Common sizing mistakes

  • Sizing from the old tank's gallons. A 50-gallon tank and a tankless unit aren't comparable. Size from flow and rise.
  • Using summer water temperature. Size for winter.
  • Ignoring the gas line and vent. A unit that fits the flow math can still need gas or venting work. Get it on the written quote.
  • Buying before checking UEF. The rebate depends on the rating, not the brand.
  • Missing the filing window. ONG and Atmos each set a filing window after purchase or installation. Check the program sheet and file soon after the job.

FAQ

Is the biggest tankless unit always the safest choice?
No. A unit sized well beyond your peak flow costs more to buy and may need gas line or venting upgrades. Size it to your realistic peak flow at your winter temperature rise.

Can one tankless water heater run two showers at once?
It depends on the showers' flow ratings and the unit's gpm at your temperature rise. Add the two shower ratings and compare the total with the unit's spec chart at your rise.

Do I need a bigger gas line for tankless?
Sometimes. The Department of Energy tankless guideline says to evaluate whether the existing gas line can supply the unit's BTU input. Your installer should confirm this in writing.

What UEF do I need for an ONG rebate?
ONG's tankless and electric-to-gas tankless rebates require UEF .80 or higher (ONG water heater sheet, Revised 09/26).

What UEF do I need for an Atmos rebate in Mid-Tex?
Atmos lists up to $200 for tankless at 0.87 UEF or higher and up to $300 at 0.95 UEF or higher, ENERGY STAR rated (program year July 1, 2026 – June 30, 2027).

Sources

Not sure which rebate your address gets? We match your ZIP to your gas and electric utility and show the water heater programs that apply.

See if you qualify →
Quick to check · No obligation.

Questions? Email [email protected].

blog author avatar

Upgrade Rebates Editorial Team

The Upgrade Rebates editorial team tracks utility and state energy-rebate programs across Texas, Oklahoma and Georgia, and checks every dollar figure against the program's own published pages before it goes on the site.

Back to Blog

Rebate budgets are first-come, first-served.

Pick your state for the programs your utility is paying right now — then check your ZIP in two minutes, no credit impact.

Independent service. Upgrade Rebates is not a government agency or utility. Program administrators determine eligibility, funding, and award amounts.